INNOPUR STONE UV PROTEC VARNISH-1K

DEFINITION
INNOPUR STONE UV PROTEC VARNISH-1K is a one-component, polyurethane-based liquid product containing high solids. It cures with moisture in the air, forming a highly durable and elastic film. It has excellent UV resistance and high hydrophobic property. Due to its aliphatic structure, it does not fade or turn yellow when exposed to sunlight. Its content is based on pure elastomeric, hydrophobic, aliphatic polyurethane resin, which gives the material excellent resistance to UV and other natural factors, as well as chemical, mechanical and thermal.

PLACE OF USE
- Tiles such as marble, ceramic.
-Natural stones.
- Patios and terraces.
-Wood surfaces
-Concrete waterproofing.

ADVANTAGES
- It has excellent weather and UV resistance.
-Thermal resistance is excellent, the product will never soften.
-Maximum service temperature 80°C; maximum shock temperature is 200°C
-Can be applied without thinning. However, if necessary, it can be thinned with a special solvent.
-Cold resistance The film retains its elasticity down to -40°C.
-It has excellent mechanical properties.
-Effective resistance to chemicals
-It is effective in water vapor permeability: Since the film breathes, moisture accumulation does not occur under the floor.

APPLICATION INFORMATION

Environmental Conditions
The relative humidity of the air should be at most 80%, the application temperature (environment and surface) should be between +3°C and +35°C.
It should not be rainy 24 hours before, during and 24 hours after the application in open areas.
The ground temperature should be 3°C above the current dew (dew falling) temperature. (Ask for the Ambient temperature-Ambient Humidity-Dew Temperature table from our company.)
Not recommended for unstable substrates. It is not applied in thick layers.

Surface types with successful results:
Tiles, cementitious roof tiles, concrete, wood, corroded metal and galvanized steel surfaces.

Surface Preparation
The surface should be cleaned using pressurized water if possible; Oil, grease, fuel and paraffin waste should be removed, as well as completely free from mold release agents, cement residues, chips, loose particles and cured membranes. The application surface must be DRY.

Lining
Does not require priming.

To mix up
It is ready to use. It can be applied without thinning. Special solvent can be used when necessary.

CONSUMPTION
Minimum total consumption: 0.1-0.3 kg/m2

PACKING INFORMATION:
20 LT, 200 LT

STORAGE INFORMATION
It can be stored for a minimum of 12 months in unopened original buckets, in dry environments at temperatures between 5°C and 25°C. The material in the opened bucket should be used as soon as possible.