INNOPUR COURT FLOOR AC-200

INNOPUR COURT FLOOR AC-200

DEFINITION
Acrylic Resurfacer is a one-component acrylic material with a concentrated 100% acrylic latex binder, applied by mixing with silica sand, and applied to asphalt and concrete floors. AREAS OF USAGE: INNOPUR COURT AC-200 Acrylic Resurfacer is used to increase the adherence of the asphalt floor and cushion system on which the sports field system will be applied, as well as it can be used as a primer before repainting the existing acrylic surfaces of the sports field.

Low temperature or high humidity increases the drying time. The maximum surface temperature is 50˚C.

SURFACE PREPARATION
For Acrylic Resurfacer application, new hot asphalt surfaces must be degassed for a minimum of 14 – 21 days. Mortar residue etc. on the cured surface. After it is removed by light sanding or brushing, the selected primer is applied. Old paint, dirt, dust, etc. on the old concrete and cement plaster surface. Loose particles such as sandblasting, scraping and brushing are removed. Oil and grease residues are cleaned with detergent water, if neutralization is required, they are washed with pressurized water. Before applying Acrylic Resurfacer, care should be taken to ensure that the floor is completely dry. Surface repairs: The court surface is wetted with water and left to dry. During drying, water accumulates in the hollow areas. After these areas are determined with chalk, they should be repaired with Acrylic Repair Binder after the surface dries completely. Primer: Priming asphalt surfaces with acrylic Primer is required if the existing asphalt is exposed to severe weather conditions. When Acrylic Resurfacer is applied to new concrete surfaces, Acrylic Primer is required for adherence.

CONSUMPTION
Acrylic Resurfacer maximum dilution ratio is 3:2. 1 kg. 4 m2 of floor can be primed with the product. However, the consumption still varies depending on the roughness of the surface.

MIXING RATIOS
Acrylic Resurfacer 60 kg Silica sand (50-55 Mesh) 60 kg

APPLICATION GUIDE

Application
Acrylic Resurfacer application should be done with the Rubber Squeege (Come Back) in the same direction as the floor. If the floor is warm, the floor should be moistened with water spray for a good application.

CLEANING
All tools used in applications can be cleaned with water without drying.

MATTERS TO BE CONSIDERED IN APPLICATION
Weather Conditions: Acrylic Resurfacer should never be applied in rainy weather (when it is raining), the surface temperature should be minimum 14˚C and maximum 50˚C for application. It should never be applied above 50˚C.

indoor applications
In indoor applications, high relative humidity, low temperature and insufficient ventilation may delay the drying time. These three factors should be taken into account especially in indoor areas. Frost protection: Since Acrylic Resurfacer is a water-based acrylic polymer, it should be protected from freezing during storage and shipping.