Natural stone flooring applications

INNOVA POLIMER-TURKEYNatural stone flooring applications

WATER PERMEABLE GRAVEL STONE FLOORING PRODUCTS   

 

INNOPUR STONE PRIMER PU-1K
It is an one-component, low viscosity, polyurethane based liquid primer that cures with moisture in the air. Specially designed to strengthen the adhesion of the products used before the pebble flooring to porous substrates..

Packing: 20 Kg, 10 Kg, 5 Kg                            Consumption: 0,1 – 0,2 Kg/m2


INNOPUR STONE PU RESIN UV-1K
It is an one-component, transparent, 100% aliphatic (non-yellowing), solvent-free, polymer-based pebble granule aggregate, specially formulated, binder resin that reacts with moisture in the air. Usage rate is maximum 4%. It has high wetting properties and cross-linking properties. Usage and setting time can be easily adjusted by the consumer.

It can be easily used on walking paths along the beach. It is not affected by sea water.

Packing: 200 Kg, 20 Kg, 10 Kg            Consumption: 100 Kg gravel stone + 4 kg polymer resin


INNOPUR STONE PU PROTECT VARNISH-1K
It is an one-component, moisture-curing, 100% aliphatic (non-yellowing), transparent or pigmented, hard-flexible polyurethane resin based long-lasting protective coating. It is applied by spray or roller on Podima stones and ceramic stones..

Packing: 20 Kg, 10 Kg, 5 Kg                            Consumption: 0,1 – 0,2 Kg/m2


APPLICATION; 

Primer application:
Concrete or asphalt ground, whose slope is correct, will be cleaned of all kinds of dust, dirt and moisture. Then, one layer, one component, polymer based, non-yellowing primer m2 / 0.2 Kg consumption will be applied to the floor by roller. Primer will ensure that the surface and floor covering material are tightly bonded and will also provide insulation by preventing concrete cracking.

It can be applied on dry, wet or even fresh concrete as an effective waterproofing and primer material that increases the durability of the substrate. Cured film has superior mechanical properties. Elongation should be> 300% and tensile strength over 30 N / mm2.

Binder Resin application:
Pebble granules, which is the first step of the application after drying of the primary layer, will be mixed with the help of a concrete mortar mixing machine or mixer for 10 minutes by adding a maximum of 4% polymer-based, one-component stone-binding polymer resin. In case of using more than 4% resin, the gaps between the pebble granules are closed and lose their water permeability and they do not transmit the water to the substrate.

Primer drying time : 1 day

Stone coating drying time: 1 day

  • Product drying times are 1 day at an average temperature of 25 degrees.
  • Drying times of applications applied under 15 degrees may take 2 days. 

MATTERS TO BE CONSIDERED;

  • In applications made under +15 degrees temperature, opening time to traffic may take 2-3 days.
  • The surface to be applied must not be wet.
  • When applying on the surface with a trowel, do not use chemical products such as trowel (soap), etc.
  • INNOPUR STONE UV RESIN should be used up to 4% of the maximum stone weight. In case of using more than 4% resin, it can bubble on the surface.

error: Content is protected !!